CSIS 331 CSIS331 Lab 3 Answer Sheet Solution - Liberty

CSIS 331 CSIS331 Lab 3 Answer Sheet Solution - Liberty

soffix

  • $9.99


CSIS 331 Lab 3 Answer Sheet Solution (Liberty University)

Submit this completed document with your completed and saved packet tracer in the link provided in Blackboard. 

Part 1: Questions.

Step 1:

a. Which command displays the statistics for all interfaces configured on a router? 

b. Which command displays the information about the Serial 0/0/0 interface only? 

c. 1) What is the IP address configured on R1? 

c. 2) What is the bandwidth on the Serial 0/0/0 interface? 

d. 1) What is the IP address on R1? 

d. 2) What is the MAC address of the GigabitEthernet 0/0 interface?

d. 3) What is the bandwidth on the GigabitEthernet 0/0 interface? 

Step 2. Questions.

a. Which command displays a brief summary of the current interfaces, statuses, and IP addresses assigned to them?

b. 1) How many serial interfaces are there on R1 and R2? 

b. 2) How many Ethernet interfaces are there on R1 and R2? 

b. 3) Are all the Ethernet interfaces on R1 the same? If no, explain the difference(s). 

Step 3: Display the routing table on R1. 

a. What command displays the content of the routing table?

b. 1) How many connected routes are there (uses the C code)?

b. 2) Which route is listed? 

b. 3) How does a router handle a packet destined for a network that is not listed in the routing table? 

Part 2 Step 3

a. What command did you use?

Part 3 Step 1

a. 1) How many interfaces on R1 and R2 are configured with IP addresses and in the “up” and “up” state?

a. 2) What part of the interface configuration is NOT displayed in the command output?

a. 3) What commands can you use to verify this part of the configuration?

b. 1) How many connected routes (uses the C code) do you see on each router? 

b. 2) How many EIGRP routes (uses the D code) do you see on each router? 

b. 3) If the router knows all the routes in the network, then the number of connected routes and dynamically learned routes (EIGRP) should equal the total number of LANs and WANs. How many LANs and WANs are in the topology?

b. 4) Does this number match the number of C and D routes shown in the routing table?


We Also Recommend


Sale

Unavailable

Sold Out